Home › Vehicle Exterior › WIPER / WASHER › RAIN SENSOR
RM2030EQ _59 Vehicle Exterior _014679 WIPER / WASHER _0074719 RAIN SENSOR A

WIPER / WASHER  RAIN SENSOR  REMOVAL  


PROCEDURE

Hide 89943 1.REMOVE RAIN SENSOR COVER

a.
E245882

Disengage the 2 claws and remove the rain sensor cover as shown in the illustration.


Hide 89941 2.REMOVE RAIN SENSOR

a.
E245883

Disconnect the connector.


b.
E246068
1.156,1.677 0.438,1.677 false 0.25,1.583 0.708,1.833 0.458,0.25 10 false *1 1.229,1.906 1.594,2.167 0.365,0.26 10 false (1) 2.469,1.542 2.813,1.854 0.344,0.313 10 false (2)
*1 Stopper


Release the stopper by pulling the stopper down and disconnect the rain sensor as shown in the illustration.


Hide 56111 3.CLEAN WINDSHIELD GLASS

HINT:
·

Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

·

Check that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue before installing the rain sensor.