Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1.INSTALL HEADLIGHT ASSEMBLY
Connect each connector.
Engage the clamp.
Install the headlight assembly with the 3 screws and bolt.
2.INSTALL FRONT BUMPER ASSEMBLY
3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (for HID Headlight)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
4.ADJUST HEADLIGHT AIMING
5.ADJUST FOG LIGHT AIMING