Home › Vehicle Exterior › LIGHTING (EXT) › HIGH INTENSITY DISCHARGE HEADLIGHT BULB › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074721 HIGH INTENSITY DISCHARGE HEADLIGHT BULB A

LIGHTING (EXT)  HIGH INTENSITY DISCHARGE HEADLIGHT BULB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Click hereVehicle Exterior>LIGHTING (EXT)>LIGHTING SYSTEM>PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 81108 3.REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY

CAUTION:

The headlight light control ECU sub-assembly may be hot when the light control switch is in the HEAD position or right after it is turned off. Check that the headlight light control ECU sub-assembly is not hot before starting work.


a.

Disconnect the connector.


b.
E226753

Turn the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and disconnect it.

NOTICE:
·

Do not apply excessive force using a tool.

·

Do not damage the O-ring or allow it to become contaminated with foreign matter. If the O-ring is damaged or contaminated, water may get into the headlight assembly, resulting in a malfunction of the headlight light control ECU sub-assembly.




c.
E226754

Turn the socket of the headlight light control ECU sub-assembly in the direction indicated by the arrow shown in the illustration, and remove it.

NOTICE:

Do not pull the headlight light control ECU sub-assembly with the socket connected.



Hide 81110L 4.REMOVE DISCHARGE HEADLIGHT BULB

a.
E226755E02
2.271,0.292 2.552,0.521 0.281,0.229 10 true (1) 1.531,0.156 1.823,0.406 0.292,0.25 10 true (1) 0.906,1.219 1.146,1.469 0.24,0.25 10 true (2)

Release the set spring as shown in the illustration and remove the discharge headlight bulb.

NOTICE:

Do not touch the bulb glass.