Home › Vehicle Exterior › LIGHTING (EXT) › REAR COMBINATION LIGHT ASSEMBLY
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074724 REAR COMBINATION LIGHT ASSEMBLY A

LIGHTING (EXT)  REAR COMBINATION LIGHT ASSEMBLY  DISASSEMBLY  


PROCEDURE

Hide 81562A 1.REMOVE REAR COMBINATION LIGHT GASKET

a.
E245839

Remove the rear combination light gasket.

NOTICE:
·

Be sure to remove all the traces of the old gasket from the body.

·

Do not reuse the removed gasket. Be sure to install a new rear combination light gasket to prevent water ingress.




Hide 81550L 2.REMOVE REAR TURN SIGNAL LIGHT BULB

a.
E245840

Turn the rear turn signal light socket with the rear turn signal light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


b.

Remove the rear turn signal light bulb from the rear turn signal light socket.


Hide 81550H 3.REMOVE TAIL AND STOP LIGHT BULB

a.
E245841

Turn the tail and stop light socket with the tail and stop light bulb in the direction indicated by the arrow shown in the illustration, and remove them as a unit.


b.

Remove the tail and stop light bulb from the tail and stop light socket.


Hide 52562F 4.REMOVE REAR BUMPER UPPER SIDE RETAINER

a.
E245842

Using a screwdriver, disengage the claw and remove the rear bumper upper side retainer as shown in the illustration.