Home › Vehicle Exterior › LIGHTING (EXT) › REAR LIGHT ASSEMBLY › 2012.02–2016.05
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074725 REAR LIGHT ASSEMBLY G

LIGHTING (EXT)  REAR LIGHT ASSEMBLY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR LIGHT ASSEMBLY LH

a.
E220265C05
0.18,0.168 0.337,0.314 0.157,0.146 10 *a 1.04,1.715 1.149,1.861 0.110,0.146 10 E 1.439,1.343 1.156,1.693 false 2.287,1.715 2.430,1.861 0.143,0.146 10 B 2.002,1.343 2.286,1.693 false 1.489,0.126 1.952,0.412 0.463,0.286 1.569,0.183 1.841,0.339 0.272,0.156 10 T20
*a Front view of wire harness connector
(to Rear Light Assembly LH)


Disconnect the connector from the rear light assembly LH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T20-2 (B)- T20-1 (E) Engine started and the shift lever not in R Below 1 V
Engine started and the shift lever in R 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.


Hide 2.INSPECT REAR LIGHT ASSEMBLY RH

a.
E220265C06
0.18,0.168 0.337,0.314 0.157,0.146 10 *a 1.04,1.715 1.149,1.861 0.110,0.146 10 E 1.439,1.343 1.156,1.693 false 2.287,1.715 2.426,1.861 0.139,0.146 10 B 2.002,1.343 2.286,1.693 false 1.489,0.126 1.952,0.412 0.463,0.286 1.58,0.183 1.852,0.339 0.272,0.156 10 T19
*a Front view of wire harness connector
(to Rear Light Assembly RH)


Disconnect the connector from the rear light assembly RH.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T19-2 (B)- T19-1 (E) Engine started and the shift lever not in R Below 1 V
Engine started and the shift lever in R 11 to 14 V


If the result is not as specified, repair or replace the wire harness or connector.