Home › Vehicle Exterior › LIGHTING (EXT) › HAZARD WARNING SWITCH
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074729 HAZARD WARNING SWITCH G

LIGHTING (EXT)  HAZARD WARNING SWITCH  INSPECTION  


PROCEDURE

Hide 55900 1.INSPECT AIR CONDITIONING CONTROL ASSEMBLY (HAZARD SWITCH)

a.
E216456
2.037,0.405 2.342,0.578 0.306,0.173 10 HAZ 0.965,0.405 1.306,0.578 0.34,0.173 10 GND 0.166,0.147 0.666,0.32 0.5,0.173 10 *a 1.248,0.599 1.566,1.158 false 2.151,0.599 1.833,1.158 false
*a Component without harness connected
(Air Conditioning Control Assembly (Hazard Switch))


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (HAZ) - 6 (GND) Hazard switch off 10 kΩ or higher
Hazard switch on Below 1 Ω


If the result is not as specified, replace the heater control switch board.