Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT LEVELING SWITCH › 2012.02–2013.07
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074730 HEADLIGHT LEVELING SWITCH G

LIGHTING (EXT)  HEADLIGHT LEVELING SWITCH  INSPECTION  


PROCEDURE

Hide 84152 1.INSPECT HEADLIGHT LEVELING SWITCH

a.

Voltage Check

i.
E190203
1.327,1.471 0.904,1.86 false 1.83,1.471 1.944,1.86 false 0.792,1.879 0.945,2.042 0.153,0.163 10 E 1.936,1.879 2.064,2.042 0.128,0.163 10 T 2.105,1.471 2.529,1.86 false 2.537,1.879 2.666,2.042 0.128,0.163 10 B 0.181,0.149 0.435,0.312 0.255,0.163 10 *a
*a Component without harness connected
(Headlight Leveling Switch)


Connect a positive (+) lead from the battery to terminal 1 (B) and a negative (-) lead to terminal 4 (E).


ii.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Position Specified Condition
2 (T) - 4 (E) 0 10.44 to 11.16 V
1 8.52 to 9.24 V
2 6.6 to 7.32 V
3 4.68 to 5.4 V
4 2.76 to 3.48 V
5 0.84 to 1.56 V


HINT:

Battery voltage is 12 V.


If the result is not as specified, replace the headlight leveling switch.



b.
E190203
1.327,1.471 0.904,1.86 false 1.573,1.471 1.996,1.86 false 0.792,1.879 0.945,2.042 0.153,0.163 10 E 1.884,1.879 2.179,2.042 0.295,0.163 10 ILL+ 0.181,0.149 0.435,0.312 0.255,0.163 10 *a
*a Component without harness connected
(Headlight Leveling Switch)


Illumination Inspection

i.

Apply battery voltage to the headlight leveling switch and check that the switch illuminates.

OK:
Tester Connection Specified Condition
Battery positive (+) → Terminal 3 (ILL+)
Battery negative (-) → Terminal 4 (E)
Illuminates


If the result is not as specified, replace the headlight leveling switch.