1. PRECAUTION (for RHD with Smart Entry and Start System)
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for RHD with Smart Entry and Start System)
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
62312B
3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
55318C
4.REMOVE INSTRUMENT SIDE PANEL
55431B
5.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)
55650
6.REMOVE NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY
55410C
7.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
84155
8.REMOVE HEADLIGHT SWIVEL MAIN SWITCH (AFS OFF SWITCH)
for LHD:
Disengage the 2 claws and remove the headlight swivel main switch (AFS OFF switch).
for RHD:
Disengage the 2 claws and remove the headlight swivel main switch (AFS OFF switch).