Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074734 HEIGHT CONTROL SENSOR G

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSPECTION  


PROCEDURE

Hide 89407C 1.INSPECT REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

a.

Connect 3 dry cell batteries (1.5 V) in series.

NOTICE:

Do not use rechargeable batteries as they may not output a voltage of 1.5 V.


E276709
5.25,1.25 5.417,1.25 5.417,1.25 5.729,1.646 false 5.917,1.594 5.917,0.833 5.917,0.833 6.083,0.833 false 6.063,1.594 6.063,1.094 6.063,1.094 6.229,1.094 false 2.094,0.052 2.552,0.25 0.458,0.198 10 false Low 2.49,0.698 3.104,0.896 0.615,0.198 10 false -45° 2.125,1.25 2.375,1.427 0.25,0.177 10 false 4° 2.531,1.385 3.448,1.583 0.917,0.198 10 false Normal 2.24,2.021 2.854,2.219 0.615,0.198 10 false +45° 1.781,2.531 2.396,2.729 0.615,0.198 10 false High 3.917,0.438 4.229,0.635 0.313,0.198 10 false *a 4.938,1.177 5.396,1.375 0.458,0.198 10 false SHB 6.135,0.75 6.75,0.948 0.615,0.198 10 false SHRR 6.26,1 6.719,1.198 0.458,0.198 10 false SHG
*a Component without harness connected
(Rear Height Control Sensor Sub-assembly)
- -



b.

Connect the positive (+) lead from the batteries to terminal 3 (SHB) and the negative (-) lead from the batteries to terminal 1 (SHG).


c.

Measure the voltage between terminals 2 (SHRR) and 1 (SHG) while slowly moving the link up and down.

Standard Voltage:
Tester Connection Condition Specified Condition
2 (SHRR) - 1 (SHG) +45° (High) 4.05 V
2 (SHRR) - 1 (SHG) 0° (Normal) 2.25 V
2 (SHRR) - 1 (SHG) -45° (Low) 0.45 V


If the result is not as specified, replace the rear height control sensor sub-assembly.