1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
89407C
3.REMOVE REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY
Disconnect the connector.
Remove the 3 nuts and rear height control sensor sub-assembly.
Do not drop the rear height control sensor sub-assembly. If it is dropped, replace it with a new one.