HID HEADLIGHT SYSTEM
Light Control ECU
The light control ECU stops illuminating the HID headlights when any of the following abnormalities are detected.
| Condition | Content |
|---|---|
| Open in output side circuit | ·
Stops illuminating the headlights. ·
Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position). |
| Short between output terminals | ·
Stops illuminating the headlights. ·
Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position). |
| Leak between output terminal and body ground | ·
Stops illuminating the headlights. ·
Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position). |
| Excessively low output voltage | ·
Stops illuminating the headlights when the output voltage becomes too low (31 +/- 3 V or less). ·
Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position). |
| Excessively high output voltage | ·
Stops illuminating the headlights when the output voltage becomes too high (69 +/- 4 V or more). ·
Keeps the headlights off until the power is reinstated (by turning the light control switch from off to the head position). |
| Excessively high input voltage | ·
Stops illuminating the headlights when the input voltage becomes too high (20 +/- 3 V or more). ·
Illuminates the headlights again when the voltage returns to the operating voltage range (10 to 16 V). |
| Low input voltage | ·
Stops illuminating the headlights when the input voltage becomes too low (below 6 V). ·
Illuminates the headlights again when the voltage returns to the operating voltage range (10 to 16 V). |
AUTOMATIC LIGHT CONTROL SYSTEM
If the main body ECU (multiplex network body ECU) detects a malfunction in the automatic light control sensor, the main body ECU (multiplex network body ECU) performs fail-safe control to prohibit the automatic light control. If the low beam headlights and taillights are on, the lights will remain on until the light control switch is turned off.