Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074744 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

a.
B308053

Remove the 9 clips and cool air intake duct seal.


Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B308058
2.75,1.427 2.438,1.177 true 2.781,1.375 3.156,1.698 0.375,0.323 10 false *1
*1 Protective Tape


Put protective tape around the front bumper assembly.

HINT:

Use the same procedure for the RH side and LH side.



b.
B281852
1.958,2.583 2.323,2.583 false 2.375,2.5 2.729,2.813 0.354,0.313 10 false *1
*1 Pin Hold Clip


Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.



c.

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



d.
B308059

Remove the 6 screws.


e.
B308060

Disengage the 3 claws.

HINT:

Use the same procedure for the RH side and LH side.



f.
B308054C02
1.51,2.646 1.708,2.823 0.198,0.177 10 false *A 2.052,3.115 2.25,3.292 0.198,0.177 10 false *B
*A w/ TOYOTA Parking Assist-sensor System
*B w/ Fog Light


Pull back the side of the front bumper assembly as shown in the illustration and disconnect each connector.

NOTICE:

Do not apply excessive force when separating the front bumper.


HINT:

Use the same procedure for the RH side and LH side.



g.
B308055

Remove the 2 screws.


h.

Using a clip remover, remove the 3 clips.


i.

w/ Headlight Cleaner System:

i.
B308056

Disconnect the headlight cleaner hose and drain the washer fluid.

HINT:

Use a container to collect the washer fluid.




j.

Remove the front bumper assembly.