Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074745 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REMOVAL  


PROCEDURE

Hide 52164A 1.REMOVE REAR BUMPER PLATE LH

a.
B282084
2.917,1.76 2.26,1.542 false 0.813,2.698 0.656,2.813 false 2.979,1.688 3.313,1.927 0.333,0.24 10 false *1 0.823,2.604 1.24,2.854 0.417,0.25 10 false *2
*1 Protective Tape
*2 Hook


Using a screwdriver with the tip wrapped with protective tape, disengage the 2 claws.


b.

Disengage the hook and remove the rear bumper plate LH.


Hide 52163A 2.REMOVE REAR BUMPER PLATE RH

HINT:

Use the same procedure as for the LH side.


Hide 3.REMOVE REAR BUMPER ASSEMBLY

a.
B282080
0.99,1.083 0.771,0.802 false 1.021,1.042 1.354,1.323 0.333,0.281 10 false *1
*1 Protective Tape


Put protective tape around the rear bumper assembly.


b.
B287737

Using a clip remover, remove the 4 clips.


c.

Remove the 6 screws.


d.
B280040

Remove the 2 screws.

HINT:

Use the same procedure for the RH side and LH side.



e.
B282086

Disengage the 7 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B282088

Disengage the 6 claws as shown in the illustration.


g.

w/ TOYOTA Parking Assist-sensor System:

i.
B307989

Disengage the 4 clamps.


ii.

Disconnect the connector.



h.

Remove the rear bumper assembly.