64719A
1.REMOVE LUGGAGE COMPARTMENT DOOR COVER
81570
2.REMOVE CENTER STOP LIGHT ASSEMBLY
76085
3.REMOVE REAR SPOILER SUB-ASSEMBLY
When removing the rear spoiler sub-assembly, heat the vehicle body and rear spoiler sub-assembly using a heat light.
| Item | Temperature |
|---|---|
| Vehicle Body | 40 to 60°C (104 to 140°F) |
| Rear Spoiler Sub-assembly | 20 to 30°C (68 to 86°F) |
Do not heat the vehicle body and rear spoiler sub-assembly excessively.
Disconnect the connector.
Remove the 2 nuts.
Insert a piano wire between the vehicle body and rear spoiler sub-assembly.
| *1 | Wooden Block | *2 | Piano Wire |
| *3 | Protective Tape | *4 | No. 1 Rear Spoiler Protector |
| *5 | Clip | - | - |
Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
Pull the piano wire and scrape off the No. 1 Rear Spoiler Protector that holds the rear spoiler sub-assembly to the vehicle body.
Be careful not to damage the vehicle body.
Disengage the 2 clips and remove the rear spoiler sub-assembly.