Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074754 LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH A

EXTERIOR PANELS / TRIM  LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH  INSTALLATION  


PROCEDURE

Hide 75431 1.INSTALL LUGGAGE COMPARTMENT DOOR EMBLEM

a.

Clean the vehicle body surface.

i.

Using a heat light, heat the vehicle body surface.


ii.

Remove the double-sided tape from the vehicle body.


iii.

Wipe off any tape adhesive residue with cleaner.



b.

Clean the luggage compartment door emblem. (If reusing the luggage compartment door emblem)

i.

Using a heat light, heat the luggage compartment door emblem.


ii.

Remove the double-sided tape from the luggage compartment door emblem.


iii.

Wipe off any tape adhesive residue with cleaner.


iv.

Apply new double-sided tape to the luggage compartment door emblem.



c.

Install the luggage compartment door emblem.

i.

Using a heat light, heat the vehicle body and luggage compartment door emblem.


ii.

Remove the release paper from the luggage compartment door emblem.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



iii.
B282055

Engage the 2 pins and install the luggage compartment door emblem as shown in the illustration.



Hide 84944B 2.INSTALL LUGGAGE ELECTRICAL KEY SWITCH COVER (w/o Smart Entry and Start System)

a.

Install the luggage electrical key switch cover.


Hide 84840 3.INSTALL LUGGAGE DOOR OPENING SWITCH ASSEMBLY (w/ Smart Entry and Start System)

Hide 76801A 4.INSTALL LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

a.

Install 5 new gaskets to the luggage compartment door outside garnish sub-assembly.


b.

Install a new clip (back door outside garnish clip) and 2 new clips to the luggage compartment door outside garnish sub-assembly.


c.
B282066C05
1.844,3.031 1.844,2.792 false 1.771,3.042 2.115,3.354 0.344,0.313 10 *1
*1 Back Door Outside Garnish Clip


Engage the 3 clips to install the luggage compartment door outside garnish sub-assembly.


d.

Install the 5 nuts.


e.

w/ Smart Entry and Start System:

i.

Connect the connector.



Hide 5.INSTALL REAR LIGHT ASSEMBLY LH

Hide 6.INSTALL REAR LIGHT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 64719A 7.INSTALL LUGGAGE COMPARTMENT DOOR COVER