Use this procedure to troubleshoot the engine immobiliser system.
*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
A simple method to determine whether the battery is discharged is to operate the horn.
| Proceed to |
|---|
| NEXT |
NEXT
If the engine switch cannot be turned on (IG), communication with the intelligent tester can be confirmed by connecting the intelligent tester to the vehicle and turning a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the intelligent tester and vehicle begins.
| Proceed to |
|---|
| NEXT |
NEXT
Use the intelligent tester to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN DTC is not output. | A |
| CAN DTC is output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Use the intelligent tester to check if the LIN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| LIN DTC is not output. | A |
| LIN DTC is output. | B |
A
B
Check for DTCs and make a note of any codes that are output.
Based on the DTCs output above, proceed to each diagnostic procedure.
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| SFI system DTC is output. | B |
| Steering lock system DTC is output. | C |
| Engine immobiliser system DTC is output. | D |
A
B
C
D
Refer to Problem Symptoms Table.
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table. | A |
| Fault is listed in problem symptoms table. | B |
A
B
Data List / Active Test
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" of each diagnostic procedure.
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| Engine immobiliser system DTC is output. | B |
A
B