These DTCs are stored when the clearance warning ECU assembly cannot receive and recognize several signals via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | Lost Communication with ECM / PCM "A" | CAN communication system |
| U0101 | Lost Communication with TCM | Lost Communication with TCM | CAN communication system |
| U0142 | Lost Communication with Body Control Module "B" | Lost Communication with Body Control Module "B" | CAN communication system |
| U0155 | Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) | Lost Communication with Instrument Panel Cluster Control Module (Combination Meter) | CAN communication system |
When 2 or more DTCs starting with "U" are output simultaneously, inspect the connectors and wire harnesses of each ECU.
Clear the DTCs .
Check for DTCs .
| Result | Proceed to |
|---|---|
| DTCs (CAN communication system DTC) are output | A |
| No DTCs are output | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING