Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0076659 TOYOTA PARKING ASSIST-SENSOR SYSTEM U

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


HINT:

Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Clearance Sonar / Data List.


e.

According to the display on the intelligent tester, read the Data List.

Body Electrical > Clearance Sonar > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Main Switch Clearance sonar main switch OFF or ON OFF: Clearance sonar main switch off
ON: Clearance sonar main switch on
-
Clearance Sonar ECU Type Type of clearance sonar ECU Normal Normal: Normal clearance sonar type -
Fr Left Sensor Front left sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range)
Mid Y: Detected (Medium-range)
Mid L Y: Detected (Long-range)
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Fr Right Sensor Front right sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range)
Mid Y: Detected (Medium-range)
Mid L Y: Detected (Long-range)
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Rr Left Sensor Rear left sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range)
Mid Y: Detected (Medium-range)
Mid L Y: Detected (Long-range)
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Rr Right Sensor Rear right sensor information Undetect, Close R, Mid Y, Mid L Y, Freeze, Open or Blink Undetect: Not detected
Close R: Detected (Close-range)
Mid Y: Detected (Medium-range)
Mid L Y: Detected (Long-range)
Freeze: Sensor frozen
Open: Open in sensor
Blink: All displays blinking
-
Keep Sense Buzzer Keep sense buzzer operation Not Avail or Avail Not Avail: Buzzer stops
Avail: Buzzer sounds continuously
Customized value displayed
Fr & Rr Buzzer Volume Buzzer volume setting L, M1, M2, M3 or H L: Low volume
M1: Medium low volume
M2: Medium volume
M3: Medium high volume
H: High volume
Customized value displayed
Reverse Range Front Sensor Operation setting for front sensors F or F Stop F: Front sensors operate
F Stop: Front sensors stop
Customized value displayed
Non P/R Range Rear Sensor Operation setting for rear sensors R or R Stop R: All rear sensors operate
R Stop: All rear sensors stop
Customized value displayed
Sensor Condition N Front sensor operation Not Avail or Avail Not Avail: Front sensors not available
Avail: Front sensors available
Customized value displayed
Parking Signal Parking signal OFF or ON OFF: Shift lever in any position other than P
ON: Shift lever in P
-
Reverse Signal Reverse signal OFF or ON OFF: Shift lever in any position other than R
ON: Shift lever in R
-
Vehicle Speed Info Vehicle speed signal Snr Stop or Snr Work Snr Stop: Vehicle speed approximately 13 km/h (8.1 mph) or more (when accelerating) or approximately 9 km/h (5.6 mph) or more (when decelerating)
Snr Work: Vehicle speed less than approximately 13 km/h (8.1 mph) (when accelerating) or less than approximately 9 km/h (5.6 mph) (when decelerating)
-
Sonar Detection Sonar detection condition Stop or Work Stop: Sonar detection not operating
Work: Sonar detection operating
-
Clearance Sonar ECU ECU information Normal or Abnormal Normal: ECU normal
Abnormal: ECU not normal
-
Rr Right Freezed History Rear right sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Rr Left Freezed History Rear left sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Fr Right Freezed History Front right sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
Fr Left Freezed History Front left sensor frozen history Not Rec or Recorded Not Rec: No record history
Recorded: Record history
-
AT/MT Recognition Transmission information AT or Unknown AT: Automatic Transmission
Unknown: Unknown
-
# Codes Number of stored DTCs min.: 0, max.: 255 Number of DTCs will be displayed -


ACTIVE TEST


HINT:

Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


a.

Connect the intelligent tester to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Clearance Sonar / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Body Electrical > Clearance Sonar > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
Buzzer No. 1 clearance warning buzzer Operate or Stop Confirm that the vehicle is stopped and the engine switch on (IG)