Home › Vehicle Interior › INTERIOR PANELS / TRIM › REAR SUNSHADE SYSTEM
RM2030EQ _58 Vehicle Interior _014674 INTERIOR PANELS / TRIM _0074674 REAR SUNSHADE SYSTEM J

INTERIOR PANELS / TRIM  REAR SUNSHADE SYSTEM  Rear Sunshade does not Operate with Rear Sunshade Switch  


DESCRIPTION

When the rear sunshade switch is pushed, an operation signal is sent to the rear sunshade relay (rear window shade assembly).

WIRING DIAGRAM

B296479E07
4.24,3.156 5.948,3.667 1.708,0.51 10 false Rear Sunshade Relay (Rear Window Shade Assembly) 3.927,3.167 4.302,3.406 0.375,0.24 10 false N19 4.135,0.406 4.375,0.646 0.24,0.24 10 false B 4.135,1.042 4.417,1.271 0.281,0.229 10 false IG 4.135,1.927 4.49,2.198 0.354,0.271 10 false SW 4.125,2.719 4.354,2.958 0.229,0.24 10 false E 5.896,1.448 6.385,1.708 0.49,0.26 10 false Motor 1.146,2.396 3.25,2.708 2.104,0.313 10 false Rear Sunshade Switch Assembly 1.146,2.25 1.51,2.479 0.365,0.229 10 false I50 0.688,0.375 1.667,0.625 0.979,0.25 10 false from Battery 0.125,1.052 1.604,1.313 1.479,0.26 10 false from IG1 NO. 2 Relay 2.167,0.552 3.156,0.708 0.99,0.156 10 false ECU-B NO. 2 2.135,1.208 3.24,1.365 1.104,0.156 10 false ECU-IG1 NO. 2 3.938,0.292 4.177,0.563 0.24,0.271 10 false 8 3.948,0.938 4.323,1.25 0.375,0.313 10 false 7 3.938,1.844 4.115,2.167 0.177,0.323 10 false 5 2.604,1.813 2.802,2.031 0.198,0.219 10 false 6 1.26,1.823 1.479,2.063 0.219,0.24 10 false 3 1.417,1.823 1.75,2.083 0.333,0.26 10 false E2 2.229,1.823 2.656,2.052 0.427,0.229 10 false ECU 3.927,2.615 4.146,2.865 0.219,0.25 10 false 1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.INSPECT REAR SUNSHADE SWITCH ASSEMBLY
a.
E124884C02
1.469,1.24 1.156,1.635 false 1.979,1.24 2.083,1.635 false 0.094,0.042 0.469,0.208 0.375,0.167 10 *a 0.927,1.656 1.302,1.823 0.375,0.167 10 ECU 2.021,1.667 2.396,1.833 0.375,0.167 10 E2
*a Component without harness connected
(Rear Sunshade Switch Assembly)


Remove the rear sunshade switch assembly.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>REAR SUNSHADE SWITCH>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
6 (ECU) - 3 (E2) Rear sunshade switch pushed Below 1 Ω
6 (ECU) - 3 (E2) Rear sunshade switch not pushed 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - REAR SUNSHADE SWITCH ASSEMBLY - BODY GROUND)

NG

REPLACE REAR SUNSHADE SWITCH ASSEMBLY

2.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - REAR SUNSHADE SWITCH ASSEMBLY - BODY GROUND)
a.

Disconnect the N19 rear sunshade relay (rear window shade assembly) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
N19-5 (SW) - I50-6 (ECU) Always Below 1 Ω
N19-5 (SW) - Body ground Always 10 kΩ or higher
I50-3 (E2) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - BATTERY AND BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.CHECK HARNESS AND CONNECTOR (REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY) - BATTERY AND BODY GROUND)
a.

Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
N19-8 (B) - Body ground Always 11 to 14 V
N19-7 (IG) - Body ground Ignition switch off Below 1 V
N19-7 (IG) - Body ground Ignition switch ON 11 to 14 V


Standard Resistance:
Tester Connection Condition Specified Condition
N19-1 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE REAR SUNSHADE RELAY (REAR WINDOW SHADE ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR