Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0076674 AUTOMATIC TRANSAXLE SYSTEM C

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  P0560  System Voltage  


DESCRIPTION

The battery supplies electricity to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history and freeze frame data. If the battery voltage falls below a minimum level, these memories are cleared and the TCM determines that there is a malfunction in the power supply circuit. When the engine is next started, the TCM will illuminate the MIL and set the DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0560 System Voltage Open in TCM back-up power source circuit.
DTC is detected for 3 sec. or more (1 trip detection logic).
·

Open in back-up power source circuit

·

SFI system

·

TCM


Comes on DTC stored

HINT:

If DTC P0560 is set, the TCM does not store other DTCs.


WIRING DIAGRAM

C240537
1.02,1.935 1.517,2.112 0.497,0.177 10 Battery 2.661,1.054 3.307,1.223 0.646,0.169 10 EFI NO. 1 5.864,0.868 6.257,1.022 0.393,0.155 10 BATT 5.864,1.469 6.08,1.627 0.216,0.158 10 E1 6.061,2.503 6.411,2.672 0.35,0.169 10 TCM 6.061,2.357 6.349,2.522 0.288,0.165 10 E7 5.632,0.773 5.746,0.928 0.114,0.155 10 1 5.632,1.373 5.746,1.528 0.114,0.155 10 8 0.819,1.194 1.465,1.364 0.646,0.169 10 FL MAIN

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Powertrain / Engine / Trouble Codes.

Powertrain > Engine > Trouble Codes
50001 234

e.

Read the DTCs using the intelligent tester.

Result:
Display (DTC Output) Proceed to
No DTC A
P0560 is output (engine control system) B




A

2.INSPECT TCM (POWER SOURCE, GROUND)

B

GO TO DTC P0560 (ENGINE CONTROL SYSTEM / SFI SYSTEM)

2.INSPECT TCM (POWER SOURCE, GROUND)
a.

Disconnect the TCM connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
E7-1 (BATT) - E7-8 (E1) Always 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
E7-8 (E1) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, BODY GROUND)