Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0076674 AUTOMATIC TRANSAXLE SYSTEM D

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MANUAL SHIFTING TEST  


PERFORM MANUAL SHIFTING TEST


HINT:
·

Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transaxle.

·

If any abnormalities are found in the following test, the problem is in the transaxle itself.



a.
C241959

Disconnect the connector of the TCM.

HINT:

It is possible to deactivate the electrical shift control by disconnecting the TCM connector. The gears can then be changed mechanically with the shift lever.



b.

Drive with the TCM connector disconnected. Move the shift lever to each position to check whether the gear changes as shown in the table below.

Shift Lever Position Gear
P P
R R
D 3rd
No Shift (Gears will not change)


c.

Connect the connector of the TCM.


d.

Clear the DTCs (See page Drivetrain>U660E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>DTC CHECK / CLEAR).

Powertrain > ECT > Clear DTCs
50002 235