Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2030EQ _55 Steering _014655 POWER ASSIST SYSTEMS _0077045 POWER STEERING SYSTEM D

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  CALIBRATION  


ASSIST MAP WRITING (USING THE INTELLIGENT TESTER)


NOTICE:

Perform assist map writing if any of the following conditions occur:

The power steering ECU assembly has been replaced.


a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the intelligent tester on.


e.

Enter the following menus: Chassis / EMPS / Utility / Signal Check.

Chassis > EMPS > Utility
Tester Display
Signal Check
50005 142 3
HINT:
·

Follow the instructions on the intelligent tester to perform Signal Check.

·

With DTC C1581/26 output, performing Signal Check will cause the power steering ECU assembly to enter Test Mode and the assist map will be written automatically.




f.

Wait for at least 5 seconds.


g.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

HINT:

After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>C1581/26




ASSIST MAP WRITING (USING SST CHECK WIRE)


NOTICE:

Perform assist map writing if any of the following conditions occur:

The power steering ECU assembly has been replaced.


a.
C248264
1.625,0.813 1.625,0.406 false 1.635,1.854 1.635,1.479 false 1.49,0.219 1.958,0.563 0.469,0.344 10 false CG 1.521,1.875 1.823,2.083 0.302,0.208 10 false TS 0.167,0.115 0.542,0.49 0.375,0.375 10 false *1
*1 DLC3


Turn the ignition switch off.


b.

Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the terminals correctly to avoid a malfunction.



c.

Turn the ignition switch to ON.


d.

Wait for 5 seconds or more.


e.

Check for DTCs.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR

HINT:

After writing the assist map, if DTC C1581/26 is output, perform the troubleshooting procedure for DTC C1581/26.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>C1581/26