The door control receiver is used to receive radio waves relating to the entry functions of the electrical key transmitter sub-assembly. The certification ECU (smart key ECU assembly) decodes the requested electrical key transmitter sub-assembly by identifying a key code based on the electric waves received via the door control receiver. The door control receiver receives a signal from the electrical key transmitter sub-assembly and sends signals to the main body ECU (multiplex network body ECU) through the certification ECU (smart key ECU assembly). The certification ECU (smart key ECU assembly) then sends a command, according to the requested operation, to each ECU (ex. if door lock operation is requested, the certification ECU (smart key ECU assembly) sends a door lock command to the main body ECU (multiplex network body ECU)).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1242 | Wireless Door Lock Tuner Circuit Malfunction | ·
Short in RDAM to ground between the certification ECU (smart key ECU assembly) and the door control receiver. ·
Short in RDAM to ground when RCO (5 V) output from the ECU is off. |
·
Wire harness or connector ·
Door control receiver ·
Certification ECU (Smart key ECU assembly) |
When replacing or inspecting the door control receiver and wire harness, do not change the position or length of the wire harness. If the wire harness is too close to the door control receiver, entry and wireless function performance may be affected.
Before performing the inspection, check that there are no problems related to the CAN communication system.
When replacing the certification ECU (smart key ECU assembly) or electrical key transmitter sub-assembly, refer to the Service Bulletin.
This DTC is not detected within 10 seconds after the engine switch turned to off from on (IG).
Disconnect the O25 door control receiver connector.
Measure the voltage and resistance and check for pulses according to the value(s) in the table below.
| *a | Component with harness connected
(Certification ECU (Smart Key ECU Assembly)) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O1-5 (RCO) - A43-11 (E) | Always | Below 1 V → 4.5 to 5.5 V
(Pulse generation) |
| O1-17 (RDAM) - A43-11 (E) | Always | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A43-11 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the O1 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O1-17 (RDAM) - O25-5 (DATA) | Always | Below 1 Ω |
| O1-5 (RCO) - O25-4 (+5) | Always | Below 1 Ω |
| O25-1 (GND) - Body ground | Always | Below 1 Ω |
| O1-17 (RDAM) or O25-5 (DATA) - Body ground | Always | 10 kΩ or higher |
| O1-5 (RCO) or O25-4 (+5) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG