Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2012.02–2015.04
RM2030EQ _58 Vehicle Interior _014667 METER / GAUGE / DISPLAY _0074615 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0129  Lost Communication with Skid Control ECU  U0131  Lost Communication with Power Steering Control Module  U0142  Lost Communication with Main Body ECU  U0151  Lost Communication with Airbag ECU  


DESCRIPTION

The combination meter assembly communicates with the ECM, skid control ECU, power steering ECU assembly, main body ECU (multiplex network body ECU), and airbag sensor assembly via the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area
U0100 Lost Communication with ECM / PCM "A" When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with ECM continues for 2 seconds or more


·

ECM

·

CAN communication system

·

Combination meter assembly


U0129 Lost Communication with Skid Control ECU When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with skid control ECU continues for 2 seconds or more


·

Skid control ECU

·

CAN communication system

·

Combination meter assembly


U0131 Lost Communication with Power Steering Control Module When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with power steering ECU assembly continues for 3 seconds or more


·

Power steering ECU assembly

·

CAN communication system

·

Combination meter assembly


U0142 Lost Communication with Main Body ECU When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with main body ECU (multiplex network body ECU) continues for 3 seconds or more


·

Main body ECU (Multiplex network body ECU)

·

CAN communication system

·

Combination meter assembly


U0151 Lost Communication with Airbag ECU When IG voltage is 9.5 V or more and the following condition is detected:
1.

No communication with airbag sensor assembly continues for 10 seconds or more


·

Airbag sensor assembly

·

CAN communication system

·

Combination meter assembly



PROCEDURE

1.CONFIRM DTC OUTPUT
a.

Check if CAN communication system DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
DTCs are output. A
DTCs are not output. B


HINT:

If CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129, U0131, U0142, or U0151 first.



A

B