Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2030EQ _54 Brake _014650 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0077110 VEHICLE STABILITY CONTROL SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  CALIBRATION  


DESCRIPTION


a.

Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration.

Parts to be Replaced Necessary Operation
Skid control ECU (Brake actuator assembly) Perform system variant learning



SYSTEM VARIANT LEARNING (When Using the Intelligent Tester)


a.

Perform System Variant Learning.

HINT:
·

System variant learning is automatically performed immediately after Test Mode is entered.

·

If learning has not yet been performed, the slip indicator light will remains on and DTC C1288 (Error in Matching of ECUs) will be stored.



i.

Turn the ignition switch off.


ii.

Connect the intelligent tester to the DLC3.


iii.

Turn the ignition switch to ON.


iv.

Turn the intelligent tester on.


v.

Switch the skid control ECU to Test Mode using the intelligent tester. Enter the following menus: Chassis / ABS/VSC/TRAC / Utility / Test Mode.

Chassis > ABS/VSC/TRC > Utility
Tester Display
Test Mode
50005 105 166

vi.

Check that the ABS warning and slip indicator lights blink in the Test Mode pattern.

HINT:

After the skid control ECU enters Test Mode, the slip indicator light may remains on for approximately 9 seconds before starting to blink in the Test Mode pattern.



vii.

Turn the ignition switch off and disconnect the intelligent tester.




SYSTEM VARIANT LEARNING (When not Using the Intelligent Tester)


a.

Perform System Variant Learning.

HINT:
·

System variant learning is automatically performed immediately after Test Mode is entered.

·

If learning has not yet been performed, the slip indicator light will remains on and DTC 88 (Error in Matching of ECUs) will be stored.



i.

Turn the ignition switch off.


ii.
C166029C16
1.594,0.906 1.594,0.5 false 1.594,1.875 1.594,1.469 false 1.51,1.896 1.75,2.073 0.24,0.177 10 TS 1.5,0.313 1.802,0.49 0.302,0.177 10 CG 0.167,0.135 0.385,0.313 0.219,0.177 10 *a
*a Front view of DLC3


Using SST, connect terminals TS and CG of the DLC3.

SST
09843-18040  


iii.

Turn the ignition switch to ON.


iv.

Check that the ABS warning and slip indicator lights blink in the Test Mode pattern.

HINT:

After the skid control ECU enters Test Mode, the slip indicator light may remains on for approximately 9 seconds before starting to blink in the Test Mode pattern.



v.

Turn the ignition switch off and disconnect SST from the DLC3.