Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM
RM2030EQ _54 Brake _014650 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0077110 VEHICLE STABILITY CONTROL SYSTEM C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM  C1432  Steering Angle Sensor Power Source Voltage Malfunction  


DESCRIPTION

This DTC is stored when the skid control ECU receives a +B line open signal from the steering angle sensor.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1432 Steering Angle Sensor Power Source Voltage Malfunction With the +BS terminal voltage 9.6 to 16.5 V, the steering angle sensor power supply circuit malfunction signal is received from the steering angle sensor.
·

Steering angle sensor power supply

·

Steering angle sensor



PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER SOURCE TERMINAL)
a.
C156493C08
0.323,1.063 0.792,1.365 0.469,0.302 2.156,2.688 2.594,3.073 false 1.958,2.583 2.594,2.104 false 0.26,0.24 0.615,0.688 0.354,0.448 10 *a 0.479,1.135 0.875,1.406 0.396,0.271 10 I29 2.635,1.99 2.938,2.313 0.302,0.323 10 IG 2.51,3.083 2.823,3.302 0.313,0.219 10 BAT
*a Front view of wire harness connector
(to Steering Angle Sensor)


Remove the steering wheel and the column cover.


b.

Make sure that there is no looseness at the locking part and the connecting part of the connector.


c.

Disconnect the I29 steering angle sensor connector.


d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I29-5 (BAT) - Body ground Always 11 to 14 V
I29-4 (IG) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE CIRCUIT)

2.CHECK HARNESS AND CONNECTOR (GROUND TERMINAL)
a.
C156493C09
0.333,1.135 0.802,1.438 0.469,0.302 1.302,2.688 0.865,3.042 false 0.281,0.208 0.625,0.688 0.344,0.479 10 *a 0.49,1.208 0.927,1.552 0.438,0.344 10 I29 0.656,3.052 1.021,3.24 0.365,0.188 10 ESS
*a Front view of wire harness connector
(to Steering Angle Sensor)


Turn the ignition switch off.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I29-1 (ESS) - Body ground Always Below 1 Ω


HINT:

If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing parts.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>PROBLEM SYMPTOMS TABLE



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (GROUND CIRCUIT)