Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM › 2012.02–2015.04
RM2030EQ _58 Vehicle Interior _014666 LIGHTING (INT) _0074614 LIGHTING SYSTEM W

LIGHTING (INT)  LIGHTING SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE LIGHTING SYSTEM (INT)


a.

Customizing using the intelligent tester

HINT:

The following items can be customized.


NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON.


iii.

Turn the intelligent tester on.


iv.

Enter the following menus: Body / Main Body / Utility / Customize / Illuminated Entry.


v.

Select the setting by referring to the table below.

Illuminated Entry
Tester Display Description Default Setting ECU
Lighting Time Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ON or ACC.) 15 s 10:30 s,00:15 s,01:7.5 s Main body ECU (Multiplex network body ECU)
I/L when ACC OFF Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when the ignition switch is turned from ON or ACC to off. ON 0:OFF,1:ON Main body ECU (Multiplex network body ECU)
I/L ON W/Door Key Unlock Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when doors are unlocked using a mechanical key or door control transmitter. ON 0:OFF,1:ON Main body ECU (Multiplex network body ECU)
Room Light when Aprchd Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when a key enters any actuation area around the doors. ON 0:OFF,1:ON Main body ECU (Multiplex network body ECU)
Interior Light Control Lights up the engine switch illumination*1, ignition key cylinder light*2, personal light*3 and rear interior light when the illuminated entry function is operating. ON 0:OFF,1:ON Main body ECU (Multiplex network body ECU)
50006 6

*1: w/ Smart Entry and Start System

*2: w/o Smart Entry and Start System

*3: w/ Sliding Roof




b.

Customizing using the Multi-display (for Navigation Receiver Type)

i.

Turn the ignition switch to ON.


ii.

Enter the following menus: SETUP / Vehicle / Vehicle customization / Light Settings


iii.

Select the setting by referring to the table below:

Display Default Content Setting Relevant ECU
Interior Lights Off Timer 15 sec. Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON.) Off, 7.5 sec., 15 sec., or 30 sec. Main body ECU (Multiplex network body ECU)