Each swivel motor receives operation signals from the AFS ECU (headlight swivel ECU assembly) and sends signals indicating the direction of the headlight and condition of the headlight swivel motor to the AFS ECU (headlight swivel ECU assembly).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2412 | Headlight Swivel Motor LH Malfunction | ·
Malfunction in headlight swivel motor LH ·
Open or short in headlight swivel motor LH circuit |
·
Headlight swivel motor LH ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
| B2413 | Headlight Swivel Motor RH Malfunction | ·
Malfunction in headlight swivel motor RH ·
Open or short in headlight swivel motor RH circuit |
·
Headlight swivel motor RH ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2412 or B2413 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Active Test.
Check that the swivel motors operate.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive Swivel Motor LH | Swivel motor LH direction rotation | Left/Right/Stop | Perform the active test with the engine started and vehicle stopped. |
| Drive Swivel Motor RH | Swivel motor RH direction rotation | Left/Right/Stop | Perform the active test with the engine started and vehicle stopped. |
| Tester Display |
|---|
| Drive Swivel Motor LH |
| Tester Display |
|---|
| Drive Swivel Motor RH |
Swivel motors operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit with a new or a known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2412 or B2413 is stored when the AFS ECU (headlight swivel ECU assembly) receives a signal indicating an abnormality from a headlight swivel motor. It is not possible to judge whether a headlight swivel motor is normal using an Active Test, because even if the motor operates normally during the Active Test, it may still output a signal indicating an abnormality.
DTC B2412 or B2413 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly)) |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-14 (IGS) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-22 (E1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the LH side or RH side headlight unit connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-1 (SMBL) - A22-1 (SMBL) | Always | Below 1 Ω |
| A35-29 (SML) - A22-2 (SML) | Always | Below 1 Ω |
| A35-23 (SMGL) - A22-3 (SMGL) | Always | Below 1 Ω |
| A35-1 (SMBL) - Body ground | Always | 10 kΩ or higher |
| A35-29 (SML) - Body ground | Always | 10 kΩ or higher |
| A35-23 (SMGL) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-2 (SMBR) - A67-1 (SMBR) | Always | Below 1 Ω |
| A35-10 (SMR) - A67-2 (SMR) | Always | Below 1 Ω |
| A35-24 (SMGR) - A67-3 (SMGR) | Always | Below 1 Ω |
| A35-2 (SMBR) - Body ground | Always | 10 kΩ or higher |
| A35-10 (SMR) - Body ground | Always | 10 kΩ or higher |
| A35-24 (SMGR) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(AFS ECU (Headlight Swivel ECU Assembly)) |
Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-1 (SMBL) - A35-23 (SMGL) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-2 (SMBR) - A35-24 (SMGR) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit with a new or a known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2412 or B2413 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG