The headlight leveling motor receives operation signals from the AFS ECU (headlight swivel ECU assembly). The AFS ECU (headlight swivel ECU assembly) receives signals indicating the operating conditions of the headlight leveling motor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2417 | Headlight Beam Level Control Motor LH Malfunction | ·
Malfunction in headlight leveling motor LH ·
Open or short in headlight leveling motor LH circuit |
·
Headlight leveling motor LH ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
| B2418 | Headlight Beam Level Control Motor RH Malfunction | ·
Malfunction in headlight leveling motor RH ·
Open or short in headlight leveling motor RH circuit |
·
Headlight leveling motor RH ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2417 or B2418 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Connect the intelligent tester to the DLC3.
Start the engine.
Turn the intelligent tester on.
Enter the following menus: Body / AFS / Active Test.
Check that the leveling motors operate.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Drive The Leveling Motor | Leveling motor operation | Up/Down/Stop | Perform the active test with the engine started and vehicle stopped. |
| Tester Display |
|---|
| Drive The Leveling Motor |
Headlight leveling motors operate normally.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit with a new or a known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2417 or B2418 is stored when the AFS ECU (headlight swivel ECU assembly) receives a signal indicating an abnormality from a headlight leveling motor. It is not possible to judge whether a headlight leveling motor is normal using an Active Test, because even if the motor operates normally during the Active Test, it may still output a signal indicating an abnormality.
DTC B2417 or B2418 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly)) |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-15 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-22 (E1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A19 or A61 headlight unit connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-3 (LH+) - A19-1 (LHB1) | Always | Below 1 Ω |
| A35-27 (LH-) - A19-3 (LHE) | Always | Below 1 Ω |
| A35-30 (LHE) - A19-2 (LHM+) | Always | Below 1 Ω |
| A35-3 (LH+) - Body ground | Always | 10 kΩ or higher |
| A35-27 (LH-) - Body ground | Always | 10 kΩ or higher |
| A35-30 (LHE) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-4 (RH+) - A61-1 (RHB1) | Always | Below 1 Ω |
| A35-28 (RH-) - A61-3 (RHE) | Always | Below 1 Ω |
| A35-11 (RHE) - A61-2 (RHM+) | Always | Below 1 Ω |
| A35-4 (RH+) - Body ground | Always | 10 kΩ or higher |
| A35-28 (RH-) - Body ground | Always | 10 kΩ or higher |
| A35-11 (RHE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(AFS ECU (Headlight Swivel ECU Assembly)) |
Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-3 (LH+) - A35-27 (LH-) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-4 (RH+) - A35-28 (RH-) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit with a new or a known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2417 or B2418 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG