The AFS ECU (headlight swivel ECU assembly) receives a signal from each headlight leveling motor using LIN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2424 | Headlight Leveling Motor LH Communication Malfunction | ·
Malfunction in headlight leveling motor LH ·
Open or short in headlight leveling motor LH communication circuit |
·
Headlight leveling motor LH ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
| B2425 | Headlight Leveling Motor RH Communication Malfunction | ·
Malfunction in headlight leveling motor RH ·
Open or short in headlight leveling motor RH communication circuit |
·
Headlight leveling motor RH ·
Harness or connector ·
AFS ECU (headlight swivel ECU assembly) |
Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2424 or B2425 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
| *a | Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly)) |
Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-15 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Front view of wire harness connector
(to AFS ECU (Headlight Swivel ECU Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-22 (E1) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A19 or A61 headlight unit connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-3 (LH+) - A19-1 (LHB1) | Always | Below 1 Ω |
| A35-27 (LH-) - A19-3 (LHE) | Always | Below 1 Ω |
| A35-30 (LHE) - A19-2 (LHM+) | Always | Below 1 Ω |
| A35-3 (LH+) - Body ground | Always | 10 kΩ or higher |
| A35-27 (LH-) - Body ground | Always | 10 kΩ or higher |
| A35-30 (LHE) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-4 (RH+) - A61-1 (RHB1) | Always | Below 1 Ω |
| A35-28 (RH-) - A61-3 (RHE) | Always | Below 1 Ω |
| A35-11 (RHE) - A61-2 (RHM+) | Always | Below 1 Ω |
| A35-4 (RH+) - Body ground | Always | 10 kΩ or higher |
| A35-28 (RH-) - Body ground | Always | 10 kΩ or higher |
| A35-11 (RHE) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(AFS ECU (Headlight Swivel ECU Assembly)) |
Reconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-3 (LH+) - A35-27 (LH-) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A35-4 (RH+) - A35-28 (RH-) | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the headlight unit with a new or a known good one.
Click hereVehicle Exterior>LIGHTING (EXT)>HEADLIGHT ASSEMBLY>REMOVAL
Check for DTCs.
Click hereVehicle Exterior>LIGHTING (EXT)>AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)>DTC CHECK / CLEAR
DTC B2424 or B2425 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG