Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074651 AIR CONDITIONING SYSTEM U

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  TERMINALS OF ECU  


AIR CONDITIONING AMPLIFIER ASSEMBLY


E226604
5.258,0.153 5.439,0.337 0.182,0.184 10 z1 3.105,0.159 3.414,0.315 0.309,0.156 10 I77 3.03,0.112 3.366,0.336 0.336,0.224 5.162,0.112 5.498,0.336 0.336,0.224

HINT:

Check from the rear of the connector while it is connected to the air conditioning amplifier assembly.


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
I77-1 (IG+) - I77-14 (GND) B - W-B Power source (IG) Ignition switch ON 11 to 14 V
I77-1 (IG+) - I77-14 (GND) B - W-B Power source (IG) Ignition switch off Below 1 V
I77-2 (SOL+) - I77-14 (GND) W - W-B*1
GR - W-B*2
Compressor solenoid operation signal Engine running
A/C switch: on
Blower switch: LO
Pulse generation
(See waveform 1)
I77-5 (TAM) - I77-13 (SG-2) P - GR Ambient temperature sensor signal Ignition switch ON
Ambient temperature: 25°C (77°F)
1.35 to 1.75 V
I77-5 (TAM) - I77-13 (SG-2) P - GR Ambient temperature sensor signal Ignition switch ON
Ambient temperature: 40°C (104°F)
0.9 to 1.2 V
I77-7 (FLOQ) - I77-14 (GND) G - W-B*1
LG - W-B*2
A/C flow sensor signal Ignition switch ON
A/C switch: off
3.8 to 4.2 V
I77-7 (FLOQ) - I77-14 (GND) G - W-B*1
LG - W-B*2
A/C flow sensor signal Ignition switch ON
A/C switch: on
Blower switch: HI
0.7 to 3.8 V
I77-8 (LOCK) - I77-14 (GND) SB - W-B A/C lock sensor signal Engine running
Blower switch: LO
A/C switch: on
Pulse generation
(See waveform 2)
I77-9 (PRE) - I77-13 (SG-2) R - GR Air conditioning pressure sensor signal Engine running
A/C system operating
Refrigerant pressure: Abnormal pressure (more than 3025 kPa (30.9 kgf/cm2, 439 psi))
4.80 V or higher
I77-9 (PRE) - I77-13 (SG-2) R - GR Air conditioning pressure sensor signal Engine running
A/C system operating
Refrigerant pressure: Abnormal pressure (less than 176 kPa (1.8 kgf/cm2, 25 psi))
Below 0.50 V
I77-9 (PRE) - I77-13 (SG-2) R - GR Air conditioning pressure sensor signal Engine running
A/C system operating
Refrigerant pressure: Normal pressure (less than 3025 kPa (30.9 kgf/cm2, 439 psi) and more than 176 kPa (1.8 kgf/cm2, 25 psi))
0.50 to 4.80 V
I77-10 (S5-3) - I77-13 (SG-2) V - GR Power supply for air conditioning pressure sensor Ignition switch ON
A/C switch: on
4.75 to 5.25 V
I77-10 (S5-3) - I77-13 (SG-2) V - GR Power supply for air conditioning pressure sensor Ignition switch ON
A/C switch: off
Below 1 V
I77-11 (CANH) - I77-12 (CANL) V - W CAN communication system CAN communication occurring Pulse generation
I77-13 (SG-2) - Body ground GR - Body ground Ground for air conditioning pressure sensor, ambient temperature sensor Always Below 1 V
I77-14 (GND) - Body ground W-B - Body ground Ground for main power supply Always Below 1 V
I77-20 (MGC) - I77-14 (GND) B - W-B Magnetic clutch operation signal Engine running
Blower switch: LO
A/C switch: off
11 to 14 V
I77-20 (MGC) - I77-14 (GND) B - W-B Magnetic clutch operation signal Engine running
Blower switch: LO
A/C switch: on
Below 1 V
I77-21 (B) - I77-14 (GND) Y - W-B Power source (Back-up) Always 11 to 14 V
I77-22 (BLW) - I77-14 (GND) R - W-B Blower motor speed control signal Ignition switch ON
Blower switch: LO
Pulse generation
(See waveform 3)
I77-29 (TR) - I77-34 (SG-1) P - LG Room temperature sensor signal Ignition switch ON
Cabin temperature: 25°C (77°F)
1.8 to 2.2 V
I77-29 (TR) - I77-34 (SG-1) P - LG Room temperature sensor signal Ignition switch ON
Cabin temperature: 40°C (104°F)
1.2 to 1.6 V
I77-30 (S5-1) - I77-14 (GND) B - W-B Power supply for A/C flow sensor Ignition switch off Below 1 V
I77-30 (S5-1) - I77-14 (GND) B - W-B Power supply for A/C flow sensor Ignition switch ON 4.5 to 5.5 V
I77-32 (TSP) - I77-14 (GND) Y - W-B*1
R - W-B*2
Solar sensor signal (for Front passenger side) Ignition switch ON
Solar sensor subjected to electric light
0.8 to 4.3 V
I77-32 (TSP) - I77-14 (GND) Y - W-B*1
R - W-B*2
Solar sensor signal (for Front passenger side) Ignition switch ON
Solar sensor covered with a cloth
Below 0.8 V
I77-33 (TSD) - I77-14 (GND) R - W-B*1
Y - W-B*2
Solar sensor signal (for Driver side) Ignition switch ON
Solar sensor subjected to electric light
0.8 to 4.3 V
I77-33 (TSD) - I77-14 (GND) R - W-B*1
Y - W-B*2
Solar sensor signal (for Driver side) Ignition switch ON
Solar sensor covered with a cloth
Below 0.8 V
I77-34 (SG-1) - Body ground LG - Body ground Ground for room temperature sensor Always Below 1 V
I77-37 (LIN1) - I77-14 (GND) V - W-B LIN communication signal Ignition switch ON Pulse generation
z1-2 (BUS G) - Body ground - Ground for BUS IC Always Below 1 V
z1-3 (BUS) - z1-2 (BUS G) - BUS IC control signal Ignition switch ON Pulse generation
z1-4 (B BUS) - z1-2 (BUS G) - Power supply for BUS IC Always 11 to 14 V
z1-5 (SGA) - Body ground - Ground for evaporator temperature sensor Always Below 1 V
z1-6 (TEA) - z1-5 (SGA) - Evaporator temperature sensor signal Ignition switch ON
Evaporator temperature: 0°C (32°F)
1.7 to 2.1 V
z1-6 (TEA) - z1-5 (SGA) - Evaporator temperature sensor signal Ignition switch ON
Evaporator temperature: 15°C (59°F)
0.9 to 1.3 V

*1: for LHD

*2: for RHD


a.
E106664
2.99,1.198 3.396,1.438 0.406,0.24 10 false GND

Waveform 1:

Item Content
Terminal No. I77-2 (SOL+) - I77-14 (GND)
Tool Setting 5 V/DIV., 500 μs/DIV.
Vehicle Condition Engine running
A/C switch: on
Blower switch: LO


b.
E116941
0.167,0.948 0.531,1.146 0.365,0.198 10 GND

Waveform 2:

Item Content
Terminal No. I77-8 (LOCK) - I77-14 (GND)
Tool Setting 200 mV/DIV., 10 ms./DIV.
Vehicle Condition Engine running
Blower switch: LO
A/C switch: on


c.
E103396
2.917,1.656 3.313,1.865 0.396,0.208 10 false GND

Waveform 3:

Item Content
Terminal No. I77-22 (BLW) - I77-14 (GND)
Tool Setting 1 V/DIV., 500 μs/DIV.
Vehicle Condition Ignition switch ON
Blower switch: LO



AIR CONDITIONING PANEL (HEATER CONTROL SWITCH BOARD)


E182384
3.604,0.261 3.846,0.479 0.242,0.218 10 I56 3.539,0.22 3.861,0.439 0.322,0.219

HINT:

Check from the rear of the connector while it is connected to the air conditioning panel (heater control switch board).


Terminal No.
(Symbol)
Wiring Color Terminal Description Condition Specified Condition
I56-2 (IG+) - I56-6 (GND) R - W-B Power source (IG) Ignition switch off Below 1 V
I56-2 (IG+) - I56-6 (GND) R - W-B Power source (IG) Ignition switch ON 11 to 14 V
I56-6 (GND) - Body ground W-B - Body ground Ground for air conditioning panel (heater control switch board) Always Below 1 V
I56-9 (LIN1) - Body ground V - Body ground LIN communication signal Ignition switch ON Pulse generation
I56-11 (ILL+) - I56-15 (ILL-) G - W-B Light control switch signal Light control switch off Below 1 V
I56-11 (ILL+) - I56-15 (ILL-) G - W-B Light control switch signal Light control switch tail or head position 11 to 14 V
I56-15 (ILL-) - Body ground W-B - Body ground Ground for air conditioning panel (heater control switch board) illumination Always Below 1 V