The main power source is supplied to the air conditioning amplifier assembly when the ignition switch is ON.
The power is used for operating the air conditioning amplifier assembly, servo motors, etc.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| I77-1 (IG+) - Body ground | Ignition switch off | Below 1 V |
| I77-1 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I77-14 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE
NG