Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074651 AIR CONDITIONING SYSTEM J

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  Back-up Power Source Circuit  


DESCRIPTION

The back-up power source circuit for the air conditioning amplifier assembly is shown below. Power is supplied even when the ignition switch is off. The power is used for diagnostic trouble code memory, etc.

WIRING DIAGRAM

E229258
5.749,1.327 6.076,1.502 0.327,0.175 10 GND 5.454,0.599 5.626,0.774 0.172,0.175 10 21 5.454,1.234 5.626,1.409 0.172,0.175 10 14 5.299,1.799 5.662,1.974 0.363,0.175 10 I77 5.299,1.97 6.919,2.302 1.62,0.332 10 Air Conditioning Amplifier Assembly 5.749,0.693 6.062,0.868 0.313,0.175 10 B 3.423,0.932 3.915,1.106 0.492,0.175 10 A/C-B 0.811,0.684 1.586,0.859 0.775,0.175 10 from Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BATTERY)
a.

Disconnect the I77 air conditioning amplifier assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I77-21 (B) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - BODY GROUND)
a.

Disconnect the I77 air conditioning amplifier assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I77-14 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR