Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074558 REAR VIEW MONITOR SYSTEM J

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  Image from Camera for Rear View Monitor is Abnormal  


DESCRIPTION

The video signal of the rear television camera assembly is transmitted to the radio and display receiver assembly.

WIRING DIAGRAM

E226207E22
0.073,2.74 2.479,3.094 2.406,0.354 10 Radio and Display Receiver Assembly 5.396,0.646 5.573,0.813 0.177,0.167 10 3 5.396,1.177 5.573,1.344 0.177,0.167 10 2 5.396,0.104 5.573,0.271 0.177,0.167 10 6 5.396,1.719 5.573,1.885 0.177,0.167 10 5 5.615,0.74 6.031,0.906 0.417,0.167 10 CV+ 5.615,1.281 6.031,1.448 0.417,0.167 10 CV- 5.615,0.208 6.031,0.375 0.417,0.167 10 CB+ 5.615,1.823 6.083,1.99 0.469,0.167 10 CGND 2.021,1.083 2.375,1.354 0.354,0.271 10 16 2.021,1.573 2.219,1.74 0.198,0.167 10 15 2.063,2.104 2.26,2.271 0.198,0.167 10 7 1.615,0.76 2.031,0.927 0.417,0.167 10 V+ 1.615,1.281 2.031,1.448 0.417,0.167 10 V- 1.521,0.208 1.938,0.375 0.417,0.167 10 CA+ 1.406,1.813 1.875,1.979 0.469,0.167 10 CGND 1.417,2.344 1.885,2.51 0.469,0.167 10 GND1 5.469,2.979 6.948,3.354 1.479,0.375 10 Rear Television Camera Assembly 3.438,3.125 4.344,3.333 0.906,0.208 10 *1: Shielded 4.521,1.958 4.771,2.156 0.25,0.198 10 *1 3.833,1.958 4.083,2.156 0.25,0.198 10 *1 3.146,1.948 3.396,2.146 0.25,0.198 10 *1 2.063,0.563 2.24,0.729 0.177,0.167 10 8 2.073,0.031 2.25,0.198 0.177,0.167 10 7 5.469,2.792 5.667,2.958 0.198,0.167 10 T6 1.958,0.219 2.271,0.385 0.313,0.167 10 I154 1.969,2.354 2.281,2.521 0.313,0.167 10 I152 1.958,0.76 2.271,0.927 0.313,0.167 10 I154 1.969,1.292 2.281,1.458 0.313,0.167 10 I154 1.969,1.823 2.281,1.99 0.313,0.167 10 I154

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)
a.

Disconnect the I154 connector from the radio and display receiver assembly.


b.

Disconnect the T6 connector from the rear television camera assembly.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I154-8 (V+) - T6-3 (CV+) Always Below 1 Ω
I154-7 (CA+) - T6-6 (CB+) Always Below 1 Ω
I154-15 (CGND) - T6-5 (CGND) Always Below 1 Ω
I154-16 (V-) - T6-2 (CV-) Always Below 1 Ω
I154-8 (V+) - Body ground Always 10 kΩ or higher
I154-7 (CA+) - Body ground Always 10 kΩ or higher
I154-16 (V-) - Body ground Always 10 kΩ or higher
I154-15 (CGND) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (V-, CGND, CA+)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (V-, CGND, CA+)
a.
E216447C10
1.448,0.323 1.938,0.615 0.49,0.292 1.375,1.813 1.063,2.479 1.063,2.479 0.729,2.479 false 1.24,1.781 0.719,1.781 false 1.375,1.615 1.063,0.938 1.063,0.938 0.729,0.938 false 0.49,1.698 0.823,1.875 0.333,0.177 10 V- 0.271,2.406 0.708,2.583 0.438,0.177 10 CGND 0.167,0.104 0.604,0.281 0.438,0.177 10 *a 1.51,0.375 1.813,0.552 0.302,0.177 10 I154 0.385,0.854 0.719,1.031 0.333,0.177 10 CA+
*a Component with harness connected
(Radio and Display Receiver Assembly)


Reconnect the I154 connector to the radio and display receiver assembly.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I154-16 (V-) - Body ground Always Below 1 Ω
I154-15 (CGND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I154-7 (CA+) - I154-15 (CGND) Within 60 seconds of turning the ignition switch ACC 5.5 to 7.05 V



Result:
Proceed to
OK
NG



OK

3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (V+,GND1)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

3.INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY (V+,GND1)
a.

Reconnect the T6 connector to the rear television camera assembly.


b.
E265837C07
1.521,0.167 1.948,0.448 0.427,0.281 1.167,2.604 1.594,2.885 0.427,0.281 0.698,0.802 1.365,0.802 1.365,0.802 1.365,0.969 false 0.781,4.042 1.25,4.042 1.25,4.042 1.448,3.604 false 1.615,0.219 2.073,0.417 0.458,0.198 10 I154 0.302,0.177 0.76,0.375 0.458,0.198 10 *a 1.26,2.656 1.719,2.854 0.458,0.198 10 I152 0.396,3.958 0.854,4.156 0.458,0.198 10 GND1 0.479,0.719 0.938,0.917 0.458,0.198 10 V+
*a Component with harness connected
(Radio and Display Receiver Assembly)


E265836C04
0.625,4.469 0.781,4.469 0.781,4.469 0.969,3.781 false 1.438,4.479 1.302,4.479 1.302,4.479 1.115,3.708 false 0.677,2.292 0.813,2.292 0.813,2.292 0.938,1.719 false 1.396,2.271 1.25,2.271 1.25,2.271 1.063,1.594 false 0.208,0.156 0.521,0.354 0.313,0.198 10 *a 0.51,2.208 0.823,2.406 0.313,0.198 10 *c 0.229,2.385 0.542,2.583 0.313,0.198 10 *b 1.427,2.198 1.74,2.396 0.313,0.198 10 *d 0.469,4.375 0.781,4.573 0.313,0.198 10 *c 1.479,4.396 1.792,4.594 0.313,0.198 10 *d 0.115,3.323 0.51,3.51 0.396,0.188 10 GND 0.083,1.063 0.479,1.25 0.396,0.188 10 GND
*a Waveform 1 (camera lens not covered, displaying an image)
*b Waveform 2 (camera lens covered, blacking out the screen)
*c Synchronization Signal
*d Video Waveform


Check the waveform of the rear television camera assembly using an oscilloscope.

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.


OK:

Waveform is similar to that shown in the illustration.


Item Content
Terminal No. (Symbol) I154-8 (V+) - I152-7 (GND1)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY