This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.
This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1ABC | Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete | A beam axis inspection has not been performed. | Blind spot monitor sensor LH |
Perform beam axis inspection using the intelligent tester.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK
| Tester Display |
|---|
| BSM Slave Beam Axis Inspection |
| Proceed to |
|---|
| NEXT |
NEXT