When the blind spot monitor main switch (warning canceling switch assembly) is turned on, a signal is sent to the blind spot monitor sensor RH. The blind spot monitor system operates according to this signal.
Inspect the fuse for circuits related to this system before performing the following procedure.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Blind Spot Monitor Master / Data list.
According to the display on intelligent tester, read the Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Main Switch | Blind spot monitor main switch (warning canceling switch assembly) | OFF or ON | ON: Blind spot monitor main switch (warning canceling switch assembly) on
OFF: Blind spot monitor main switch (warning canceling switch assembly) off |
- |
| Tester Display |
|---|
| Main Switch |
| Result | Proceed to |
|---|---|
| The display does not change as shown above when the blind spot monitor main switch (warning canceling switch assembly) is operated. | A |
| The display changes as shown above when the blind spot monitor main switch (warning canceling switch assembly) is operated. | B |
A
B
Remove the blind spot monitor main switch (warning canceling switch assembly).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR MAIN SWITCH>REMOVAL
| *a | Component without harness connected
(Blind Spot Monitor Main Switch (Warning Canceling Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I157-11 (B) - I157-8 (D) | Blind spot monitor main switch assembly is on (not protruding) | Below 1 Ω |
| I157-11 (B) - I157-8 (D) | Blind spot monitor main switch assembly is off (protruding) | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR MAIN SWITCH>REMOVAL
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I157-11 (B) - Body ground | Engine switch on (IG) | 11 to 14 V |
| I157-11 (B) - Body ground | Engine switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| O28-3 (BSSW) - I157-8 (D) | Always | Below 1 Ω |
| O28-3 (BSSW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG