CUSTOMIZE METER / GAUGE SYSTEM
Customizing with the intelligent tester
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Customize Setting / Combination Meter / Warning.
Select the setting by referring to the table below.
Be sure to record the current value before customizing.
| Tester Display | Description | Default | Setting | ECU |
|---|---|---|---|---|
| Key Remind Sound | Function to change the cycle of the key remind warning buzzer | Slow | 00:Normal,01:Slow,10:Fast | Combination meter assembly |
| Driver Side Seatbelt Warning Buzzer | Function to turn on/off the seat belt warning buzzer*1 | ON | 0:OFF,1:ON | Combination meter assembly |
| Front Passenger Side Seatbelt Warning Buzzer | Function to turn on/off the seat belt warning buzzer*1 | ON | 0:OFF,1:ON | Combination meter assembly |
| Rear Seatbelt Warning Buzzer | Function to turn on/off the seat belt warning buzzer*2 | ON | 0:OFF,1:ON | Combination meter assembly |
*1: This setting is only valid for the buzzer which sounds at 20 km/h (12 mph) or more
*2: for RHD
Customizing with the combination meter assembly
Press and hold the ODO/TRIP change switch to enter the mode.
Briefly press the ODO/TRIP change switch to select an item.
Turn the ignition switch to ON.
Select the setting by referring to the table below.
Be sure to record the current value before customizing.
| Combination meter assembly display | Default | Content | Setting | Relevant ECU |
|---|---|---|---|---|
| LANGUAGE | ENGLISH | Function to change the multi-information display language | ENGLISH, FRENCH, SPANISH | Combination meter assembly |
| ECO INDICATOR | ON | Function to display/not display the eco indicator and current fuel economy display | ON or OFF | Combination meter assembly |
Press and hold the ODO/TRIP change switch.
Return to the item selection screen.