Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)
RM2030EQ _56 Audio / Visual / Telematics _014658 AUDIO / VIDEO _0077308 AUDIO AND VISUAL SYSTEM(for Radio Receiver Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio Receiver Type)  Radio Receiver Power Source Circuit  


DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E211811
1.114,0.763 1.893,0.954 0.779,0.191 10 from Battery 0.46,1.953 1.887,2.144 1.427,0.191 10 from ACC NO. 1 Relay 3.626,1.001 4.259,1.192 0.633,0.191 10 RADIO-B 3.598,2.178 4.282,2.369 0.684,0.191 10 ECU-ACC 5.882,0.664 6.0,0.855 0.118,0.191 10 4 6.064,1.953 6.455,2.144 0.391,0.191 10 ACC1 5.868,1.855 5.986,2.046 0.118,0.191 10 3 5.434,4.678 5.743,4.869 0.309,0.191 10 I148 6.064,3.186 6.483,3.377 0.419,0.191 10 GND1 5.469,4.861 7.121,5.052 1.653,0.191 10 Radio Receiver Assembly 5.887,3.088 6.005,3.279 0.118,0.191 10 7 6.064,0.763 6.36,0.954 0.296,0.191 10 +B1

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BATTERY, BODY GROUND)
a.

Disconnect the radio receiver assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I148-7 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
I148-4 (+B1) - I148-7 (GND1) Always 11 to 14 V
I148-3 (ACC1) - I148-7 (GND1) Engine switch on (ACC) 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR