The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio receiver assembly through this circuit.
The sound signal that has been sent is amplified by the radio receiver assembly, and then is sent to the speakers.
If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio receiver assembly or speakers.
Disconnect the No. 1 stereo jack adapter assembly and radio receiver assembly connectors.
Measure the resistance according to the value(s) in the table below.
| *a | Front view of wire harness connector
(to Radio Receiver Assembly) |
*b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I146-9 (AUXO) - I150-25 (AUXI) | Always | Below 1 Ω |
| I146-6 (ARO) - I150-26 (ARI) | Always | Below 1 Ω |
| I146-7 (ALO) - I150-28 (ALI) | Always | Below 1 Ω |
| I146-8 (ASGN) - I150-27 (ASGN) | Always | Below 1 Ω |
| I146-10 (AGND) - I150-11 (AGND) | Always | Below 1 Ω |
| I146-2 (UDO-) - I151-2 (US1-) | Always | Below 1 Ω |
| I146-3 (UDO+) - I151-3 (US1+) | Always | Below 1 Ω |
| I146-5 (UJSS) - I151-5 (USG1) | Always | Below 1 Ω |
| I146-9 (AUXO) - Body ground | Always | 10 kΩ or higher |
| I146-6 (ARO) - Body ground | Always | 10 kΩ or higher |
| I146-7 (ALO) - Body ground | Always | 10 kΩ or higher |
| I146-8 (ASGN) - Body ground | Always | 10 kΩ or higher |
| I146-10 (AGND) - Body ground | Always | 10 kΩ or higher |
| I146-2 (UDO-) - Body ground | Always | 10 kΩ or higher |
| I146-3 (UDO+) - Body ground | Always | 10 kΩ or higher |
| I146-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG