Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › TOYOTA PARKING ASSIST-SENSOR SYSTEM › from 2013.07
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0076659 TOYOTA PARKING ASSIST-SENSOR SYSTEM W

PARK ASSIST / MONITORING  TOYOTA PARKING ASSIST-SENSOR SYSTEM  CUSTOMIZE PARAMETERS  


CUSTOMIZE TOYOTA PARKING ASSIST-SENSOR SYSTEM


a.

Customizing with the intelligent tester

NOTICE:
·

When the customer requests a change in a function, first make sure that the function can be customized.

·

Be sure to make a note of the current settings before customizing.

·

When troubleshooting a function, first make sure that the function is set to the default setting.



i.

Connect the intelligent tester to the DLC3.


ii.

Turn the engine switch on (IG).


iii.

Turn the clearance sonar main switch on.


iv.

Turn the intelligent tester on.


v.

Enter the following menus: Body / Clearance Sonar / Utility / Customize.


vi.

Select the setting by referring to the table below.

Warning
Tester Display Description Default Setting ECU
Keep Sense Buzzer Sounds the buzzer when the distance between the vehicle and obstacle does not change for more than 3 seconds. Avail 0:Not Avail,1:Avail Clearance warning ECU assembly
Fr & Rr Buzzer Volume Changes the buzzer volume setting. H 001:L,010:M1,011:M2,100:M3,101:H Clearance warning ECU assembly
50006 7
Sensor
Tester Display Description Default Setting ECU
Sensor Condition N Makes the front sensors available when the shift lever is in N. Avail 0:Not Avail,1:Avail Clearance warning ECU assembly
Reverse Range Front Sensor Changes the operation setting for the front sensors when the shift lever is in R. F 0:F,1:F Stop Clearance warning ECU assembly
Non P/R Range Rear Sensor Changes the operation setting for the rear sensors when the shift lever is in any position other than P or R. R Stop 0:R,1:R Stop Clearance warning ECU assembly
50006 13