Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM › from 2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0164667 AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM C

LIGHTING (EXT)  AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM  B2452  Height Control Sensor Data Out of Range When Initializing  


DESCRIPTION

The headlight leveling ECU assembly stores this DTC if the sensor value received from the rear height control sensor sub-assembly is out of range when performing initialization of the headlight leveling ECU assembly; for example, the vehicle is not level or being jacked up.

DTC No. Detection Item DTC Detection Condition Trouble Area
B2452 Height Control Sensor Data Out of Range When Initializing Vehicle condition not specified when initializing
·

Vehicle condition when initializing

·

Headlight leveling ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the headlight leveling ECU assembly has been replaced, initialization of the headlight leveling ECU assembly is necessary.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION


PROCEDURE

1.PERFORM INITIALIZATION
a.

Perform initialization of the headlight leveling ECU assembly.

Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HEADLIGHT BEAM LEVEL CONTROL SYSTEM>INITIALIZATION

HINT:
·

Before initializing the headlight leveling ECU assembly, make sure that the vehicle conditions are proper for initialization.

·

Be sure to perform initialization as instructed.




Result:
Proceed to
NEXT



NEXT

2.RECHECK FOR DTC
2.RECHECK FOR DTC
a.

Using the intelligent tester, recheck for DTCs.

Body Electrical > HL AutoLeveling > Trouble Codes
50001 165
OK:

DTC B2452 is not output


HINT:

If the headlight leveling ECU assembly stores DTC B2452 even though the ECU has been initialized as instructed, there may be a malfunction in the headlight leveling ECU assembly.



Result:
Proceed to
OK
NG



OK

END

NG

REPLACE HEADLIGHT LEVELING ECU ASSEMBLY