Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VSC OFF SWITCH(for RHD) › from 2015.04
RM2030EQ _54 Brake _014650 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0165194 VSC OFF SWITCH(for RHD) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VSC OFF SWITCH(for RHD)  INSPECTION  


PROCEDURE

Hide 84986 1.INSPECT VEHICLE STABILITY CONTROL SWITCH

a.
C311100C03
1.375,2.729 1.521,2.104 false 2.302,2.698 2.115,2.104 false 0.49,0.573 0.802,0.771 0.313,0.198 10 false *a 1.313,2.75 1.625,2.948 0.313,0.198 10 false + 2.313,2.74 2.625,2.938 0.313,0.198 10 false E
*a Component without harness connected
(Vehicle Stability Control Switch)


Make sure that there is no looseness at the locking part and the connecting part of the connector.


b.

Disconnect the vehicle stability control switch connector.


c.

Check both the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion.



d.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
9 (+) - 6 (E) Switch pushed Below 1 Ω
9 (+) - 6 (E) Switch not pushed 10 kΩ or higher


If the result is not as specified, replace the vehicle stability control switch.