Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE FRONT WHEEL
2.LOOSEN FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
Loosen the front support to front shock absorber nut.
Do not remove the front support to front shock absorber nut.
Loosen the front support to front shock absorber nut only when the front shock absorber with coil spring needs to be disassembled.
89543
3.SEPARATE FRONT SPEED SENSOR
Remove the bolt and clamp, and separate the front speed sensor and front flexible hose from the front shock absorber assembly.
Be sure to separate the front speed sensor from the front shock absorber assembly completely.
48810
4.SEPARATE FRONT STABILIZER LINK ASSEMBLY
for Steel Type:
Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.
for Aluminum Type:
Remove the nut and separate the front stabilizer link assembly from the front shock absorber assembly.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud bolt.
5.REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING
| *1 | Jack |
| *2 | Wooden Block |
|
Front of the Vehicle |
Support the front axle using a jack and wooden block.
Remove the 2 bolts and 2 nuts, and separate the front shock absorber with coil spring (lower side) from the steering knuckle.
When removing the nuts, keep the bolts from rotating.
Remove the 3 nuts and front shock absorber with coil spring.
Make sure that the front speed sensor is completely separated from the front shock absorber with coil spring.
6.REMOVE FRONT SUPPORT TO FRONT SHOCK ABSORBER NUT
Secure SST in a vise.
| *a | Correct |
| *b | Incorrect |
Attach the arms of SST to the diameter of the front coil spring.
Make sure that the front coil spring is installed so that the distance between the upper and lower arms of SST is at the maximum.
Make sure that the claws of the arms are securely attached.
Using SST, compress the front coil spring.
If the front coil spring bends during compression, immediately stop compression and reinstall SST.
Do not excessively compress the front coil spring so that the coils contact each other.
Do not use an impact wrench. It will damage SST.
Confirm that the front coil spring is free and remove the front support to front shock absorber nut.
Do not remove the front support to front shock absorber nut when the front coil spring is not free.
48609
7.REMOVE FRONT SUSPENSION SUPPORT SUB-ASSEMBLY
48609C
8.REMOVE FRONT SUSPENSION SUPPORT BEARING
48471C
9.REMOVE FRONT UPPER COIL SPRING SEAT
48157C
10.REMOVE FRONT UPPER COIL SPRING INSULATOR
| *a | Front Upper Coil Spring Insulator |
| *b | Claw |
Disengage the front upper coil spring insulator from the claws of the front shock absorber assembly.
Remove the front upper coil spring insulator from the front shock absorber assembly.
48132
11.REMOVE FRONT COIL SPRING
48331C
12.REMOVE FRONT SPRING BUMPER
48158C
13.REMOVE FRONT LOWER COIL SPRING INSULATOR
48520
14.REMOVE FRONT SHOCK ABSORBER ASSEMBLY