Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › from 2015.04
RM2030EQ _51 Engine / Hybrid System _014642 CRUISE CONTROL _0165902 LANE DEPARTURE ALERT SYSTEM C

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  U1000  CAN Communication Failure (Message Registry)  


DESCRIPTION

The lane departure warning camera monitors its internal condition. When an internal malfunction is detected, the lane departure warning camera stores DTC U1000 and cancels lane departure alert system control.

DTC No. Detection Item DTC Detection Condition Trouble Area
U1000 CAN Communication Failure (Message Registry) When the engine switch is turned on (IG), a CAN communication malfunction is detected. Lane departure warning camera

CAUTION / NOTICE / HINT

NOTICE:
·

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed.

Click hereEngine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT

·

When replacing the lane departure warning camera, always replace it with a new one. If a lane departure warning camera which was installed to another vehicle is used, the information stored in the lane departure warning camera will not match the information from the vehicle. As a result, a DTC may be stored.



PROCEDURE

1.CHECK FOR DTCS (HEALTH CHECK)
a.

Connect the GTS to the DLC3.


b.

Turn the engine switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: System Select / Health Check.


e.

Check for DTCs.

Result:
Result Proceed to
DTC U1000 only is output A
DTCs other than U1000 are output B




A

B