81110B
1.REMOVE NO. 1 HEADLIGHT BULB
Turn the No. 1 headlight bulb as shown in the illustration to remove it.
Do not touch the bulb glass.
81110D
2.REMOVE NO. 2 HEADLIGHT BULB (for Halogen Headlight)
Turn the No. 2 headlight bulb as shown in the illustration to remove it.
Do not touch the bulb glass.
81144C
3.REMOVE HEADLIGHT SOCKET COVER
for Halogen Headlight:
Remove the 2 headlight socket covers from the headlight unit.
for LED Headlight:
Remove the headlight socket cover from the headlight unit.
81510C
4.REMOVE FRONT TURN SIGNAL LIGHT BULB
for Halogen Headlight:
Turn the front turn signal light socket with the front turn signal light bulb as shown in the illustration to remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
for LED Headlight:
Turn the front turn signal light socket with the front turn signal light bulb as shown in the illustration to remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
81610F
5.REMOVE CLEARANCE LIGHT BULB
for Halogen Headlight:
Turn the clearance light socket with the clearance light bulb as shown in the illustration to remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
for LED Headlight:
Turn the clearance light socket with the clearance light bulb as shown in the illustration to remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
85662
6.REMOVE HEADLIGHT LEVELING MOTOR (for LED Headlight)
| *a | Aiming Screw |
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (1) shown in the illustration.
Turn the aiming screw until the headlight leveling motor can be moved in the direction indicated by the arrow (2) shown in the illustration.
Make sure to remember the number of aiming screw rotations.
Turn the headlight leveling motor in the direction indicated by the arrow (2) shown in the illustration to disengage the pin.
When removing the headlight leveling motor of the headlight assembly RH, turn the headlight leveling motor in the opposite direction of the arrow (2) shown in the illustration.
| *a | Aiming Screw |
Turn the aiming screw of the headlight leveling motor in the direction indicated by the arrow (3) shown in the illustration to disengage the shaft.
Make sure to remember the number of aiming screw rotations.
Pull out the headlight leveling motor in the direction indicated by the arrow (4) shown in the illustration to remove it.
85669
7.REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING (for LED Headlight)
Remove the headlight leveling motor base packing.
After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
81108
8.REMOVE HEADLIGHT LIGHT CONTROL ECU SUB-ASSEMBLY (for LED Headlight)
Remove the 4 screws.
Disconnect the 2 connectors to remove the headlight light control ECU sub-assembly.
81134
9.REMOVE HEADLIGHT GASKET (for LED Headlight)
Remove the headlight gasket.
After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
10.REMOVE GROMMET
Using needle-nosed pliers, remove the grommet.