84978
1.INSPECT LANE DEPARTURE ALERT SWITCH (LANE-KEEPING ASSIST MAIN SWITCH)
Check the switch function.
| *a | Component without harness connected
Lane Departure Alert Switch (Lane-keeping Assist Main Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| 6 (ECU) - 3 (GND) | Lane departure alert switch (lane-keeping assist main switch) on | Below 1 Ω |
| 6 (ECU) - 3 (GND) | Lane departure alert switch (lane-keeping assist main switch) off | 10 kΩ or higher |
Check that the switch illuminates.
| *a | Component without harness connected
Lane Departure Alert Switch (Lane-keeping Assist Main Switch) |
Apply battery voltage to the lane departure alert switch (lane-keeping assist main switch) and check that the switch illuminates.
| Connection | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 5 (ILL+)
Battery negative (-) → Terminal 4 (ILL-) |
Illuminates |
If the result is not as specified, replace the lane departure alert switch (lane-keeping assist main switch).