This DTC is stored when the rear television camera assembly judges that the back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1691 | Back Camera Initialization Incomplete | Back camera initial setting has not been memorized (rear television camera assembly optical axis adjustment (back camera position setting) is incomplete) | ·
Rear television camera assembly optical axis adjustment (back camera position setting) ·
Rear television camera assembly |
If the cable was disconnected from and reconnected to the negative (-) battery terminal, the estimated course lines may not be displayed on the image of the area behind the vehicle. In this case, perform "Correct the Steering Angle Neutral Point".
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
Perform the following procedure depending on the memory conditions to register the vehicle information into the rear television camera assembly.
Rear television camera assembly optical axis adjustment (back camera position setting).
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR
If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment (back camera position setting) again.
If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the rear television camera assembly.
| Result | Proceed to |
|---|---|
| DTC C1691 is output | A |
| DTC C1691 is not output | B |
A
B