Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2015.04
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074744 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  REMOVAL  


PROCEDURE

Hide 53295E 1.REMOVE COOL AIR INTAKE DUCT SEAL

a.
B308053

Remove the 9 clips and cool air intake duct seal.


Hide 2.REMOVE FRONT BUMPER ASSEMBLY

a.
B308058C03
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the front bumper assembly as shown in the illustration.


b.
B402698C01
1.979,2.583 2.302,2.583 false 2.333,2.49 2.625,2.792 0.292,0.302 10 false *1 2.917,1.542 3.219,1.906 0.302,0.365 10 false *a
*1 Pin Hold Clip
*a 90°


Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

HINT:

Use the same procedure for the RH side and LH side.



c.

Remove the clip.

HINT:

Use the same procedure for the RH side and LH side.



d.
B308059

Remove the 6 screws.


e.
B400932

Disengage the 3 claws as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.



f.
B308054C02
1.51,2.646 1.708,2.823 0.198,0.177 10 false *A 2.052,3.115 2.25,3.292 0.198,0.177 10 false *B
*A w/ TOYOTA Parking Assist-sensor System
*B w/ Fog Light


Pull back the side of the front bumper assembly as shown in the illustration and disconnect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.


HINT:

Use the same procedure for the RH side and LH side.



g.
B308055

Remove the 2 screws.


h.

Using a clip remover, remove the 3 clips.


i.

Remove the front bumper assembly.