Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT BUMPER › from 2015.04
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074744 FRONT BUMPER A

EXTERIOR PANELS / TRIM  FRONT BUMPER  INSTALLATION  


PROCEDURE

Hide 1.INSTALL FRONT BUMPER ASSEMBLY

a.

Move the front bumper assembly into position and install the 3 clips.


b.

Install the 2 screws.


c.

Pull back the side of the front bumper assembly and connect each connector.

NOTICE:

Do not apply excessive force when pulling back the front bumper assembly.


HINT:

Use the same procedure for the RH side and LH side.



d.
B400933

Engage the 3 claws.

HINT:

Use the same procedure for the RH side and LH side.



e.

Install the 6 screws.


f.
B281853C06
1.969,2.583 2.219,2.583 false 2.958,1.167 3.229,1.448 0.271,0.281 10 false *b 2.354,1.177 2.625,1.458 0.271,0.281 10 false *a 2.229,2.479 2.479,2.781 0.25,0.302 10 false *1
*1 Pin Hold Clip
*a Correct
*b Incorrect


Install the pin hold clip as shown in the illustration.

NOTICE:

Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is aligned vertically.


HINT:

Use the same procedure for the RH side and LH side.



g.

Install the front bumper assembly with the clip.

HINT:

Use the same procedure for the RH side and LH side.



Hide 53295E 2.INSTALL COOL AIR INTAKE DUCT SEAL

a.

Install the cool air intake duct seal with the 9 clips.


Hide 3.ADJUST FOG LIGHT ASSEMBLY (w/ Fog Light)