76873
1.INSTALL NO. 2 REAR SPOILER PROTECTOR
Use the same procedure for the RH side and LH side.
Clean the rear spoiler.
Remove any remaining double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new No. 2 rear spoiler protector.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Marking |
| *b | Standard end location |
Install the No. 2 rear spoiler protector so that it is centered within the markings on the rear spoiler.
76898
2.INSTALL REAR SPOILER SIDE PROTECTOR LH
Clean the rear spoiler.
Remove any remaining double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new rear spoiler side protector LH.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the rear spoiler side protector.
76897
3.INSTALL REAR SPOILER SIDE PROTECTOR RH
Use the same procedure as for the LH side.
76874B
4.INSTALL REAR SPOILER PROTECTOR LH
Clean the rear spoiler.
Remove any remaining double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new rear spoiler protector LH.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the rear spoiler protector LH.
76873A
5.INSTALL REAR SPOILER PROTECTOR RH
Use the same procedure as for the LH side.
76872
6.INSTALL NO. 1 REAR SPOILER PROTECTOR
Use the same procedure for the RH side and LH side.
Clean the rear spoiler.
Remove any remaining double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from a new No. 1 rear spoiler protector.
After removing the release paper, keep the exposed adhesive free from foreign matter.
| *a | Marking |
| *b | Standard end location |
Install the No. 1 rear spoiler protector so that it is centered within the markings on the rear spoiler.
76887
7.INSTALL REAR SPOILER SEAL
Clean the rear spoiler.
Remove any remaining double-sided tape from the rear spoiler.
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from new rear spoiler seals.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the 3 rear spoiler seals.
76085
8.INSTALL REAR SPOILER SUB-ASSEMBLY
Install the rear spoiler sub-assembly with the 3 nuts.
64719A
9.INSTALL LUGGAGE COMPARTMENT DOOR COVER